This live feed
information is to be used as a general guide to current inventory. There is no guarantee of
availability.
FEATURES
RPM Front A-arms for the Associated Rival MT8 are designed to improve durability over stock A-arms. How did we do it? First, by increasing the amount of material surrounding the inner hinge pins by 7%. We then increased the width of that thicker diameter by nearly 40%! The amount of material at the outer hinge pins was also improved by 28%! We also increased the width there too, by another 9%.
The support beams on our A-arms also got beefier. At their thickest, stock a-arms are roughly 1/2” (12.7mm) thick, but taper down on both ends. That amounts to a loss of nearly 30% of their thickness at the outer hinge pins. Not with RPM! Our A-arms are a full 1/2” (12.7mm) over nearly their entire length! We only taper them slightly at the inner hinge pins (.45” or 11.43mm at their narrowest) to match the maximum size allowable of the inner hinge pin bosses. To compensate for that slight taper, we use four massive support beams instead of two, making RPM MT8 A-arms the toughest alternative to stock available!
