Nighthawk Pro 280 ARTF Racing Quad w/TH9X+Rx
click to enlarge
- Solid, durable and stable frame
- Prebuilt frame and extra accessories
- Built with the powerful EMAX power system and open source flight controller to ensure power and tunability
- The sturdy frame has extensive flight and endurance testing.
- Bright rear LED bar can distinguish copters when group flying. Random selection of 5 available colors: White, Red, Green, Yellow, Blue (LED power consumption is 4W)
- All in one design flight controller, ESC, BEC for easy installation and replacement.
- Plug and play motor connector, easy for field swapping motor without soldering.
- 4 Integrated 12A BLHeli ESC, 32bit ARM micro processor based flight controller and integrated BEC power supply.
- ESC switch to perform single ESC calibration and boot pad to perform software and firmware upgrade
- Supports Baseflight and Cleanflight control firmware
- Gyroscope, magnetometer, accelerometer and barometer expansion port with CPPM receiver
- GPS feature can be enabled. (GPS module sold separately)
- Support ANGLE, HORIZON, HEADFREE, MAG, HEADADJ ...etc modes.
- Support RC Input: standard signal, CPPM or PWM signal.
- Low voltage monitoring and low voltage warning. (Buzzer sold separately)
- Extra power output and power output switch for LED expansion.
- 32 Channel Video transmitter output power can be switched between 20mW & 200mW.
- Vibration dampened Mobius Camera mounting plate
The Nighthawk Pro 280 is the most complete solution to get started in the exciting world of FPV quad racing. It was designed from the ground up to meet the demands of the Drone Racer. It comes fully assembled and tuned with an integrated Skyline32 flight control board and four 12Amp BLHeli (OneShot) ESCs. The power system consists of four EMAX MT2204-2300kV motors turning 6x4.5 propellers. Included are optional 10 degree forward tilted motor mounts allowing greater flight speed as skills improve. The Nighthawk Pro 280 includes a 700TVL camera with optional reclined mount and a 32 Channel, 20mW-200mW selectable video transmitter with cloverleaf antenna.
**Please note, Our Ready-to-Fly combo includes an upgraded FlySky TH9X transmitter and Receiver, they are packaged separately and require installation/programming before flight. Other retailers include a cheaper radio with less features and less likely to grow with you in the fast paced hobby of drone racing.